|
TS-1311 Digital Tens/NMES Unit
Special Features
- Two Channels
- 3 Treatment Modes (Alternating, Synchronous
or Constant)
- Adjustable Rate & Width
- Adjustable Contraction/Relaxation Times
- Adjustable Ramp Up/Down
- Clear Protective Cap for Intensity Dials
- Treatment Timer
- Compliance Monitor
- Last Setting Recall
- Low Battery Indicator
Technical Specifications
- Channels: Dual, isolated between channels
- Waveform: Asymmetrical biphasic square pulse
- Amplitude: Adjustable 0-80 mA (40 Volts) peak into 500 ohm load each channel
- Pulse Rate: Adjustable 2-120 pulses per second (Hz)
- Pulse Width: Adjustable 50-300 microseconds (us)
- Ramp (up/down): Adjustable 1-8 seconds
- On (Contraction) Time: Adjustable 2-99 seconds
- Off (Relaxation) Time: Adjustable 2-99 seconds
- Treatment Modes: Synchronous (S): Channels 1 and 2 stimulate ON and OFF together at the
same time. ON and OFF times apply to both channels
- Constant (C): Channels 1 and 2 stimulate ON continuously at the set
pulse rate. ON time, OFF time and Ramp do not apply
to either channel.
- Alternating (A): Channel 1 stimulates ON first, then the stimulation immediately
alternates to Channel 2.
At the end of Channel 2 cycle, then both channels are
OFF for the set OFF time..
- Patient Compliance
Timer:
Records the last 60 individual treatment sessions, with up to 999 minutes
per session, and can record the whole treatment time for all the cumulative
sessions.
- Treatment Timer: Adjustable 5-90 minutes in 5 minute increments, or Continuous.
When the remaining treatment time is 5 minutes, the clock symbol will begin
to flash every second.
- Automatic Shutoff: When using timed treatment, the unit will shut off automatically when ended,
but will beep every 10 seconds until the amplitude knob is turned off completely.
Treatment can resume by turning the amplitude back on.
- Last Setting Recall: Memorizes the last settings that were used and will recall these settings
whenever the unit is turned back on. These settings will remain the same
until they are changed.
- Low Battery Indicator: Battery symbol will flash in the LCD display when battery power level falls
below 6.5 volts, to alert user of needing a new battery soon.
- Battery: One 9 Volt DC battery (heavy duty, alkaline, or rechargeable)
Size: 100 (L) x 59 (W) x 24 (H)
|